How to Use your Soliom Solar camera S60?


How to Use Soliom Solar Camera S60?

Note that you should set up your Soliom Solar camera S60 in your Soliom app before mounting it to your wall. Click here for information on setting up your Soliom camera.

1. How to physically install your Soliom Solar camera S60?

Step one:


Line up the mounting bracket:

--Place the mounting bracket to a proper height.Suggest height is about 8ft(2.4m)--

Mark the positions of the mounting holes with a pencil.

Step Two:


Drill holes and tighten the screws

-Use a drill to drill holes where you marked the position of the mounting holes.

-If you're mounting the bracket on masonry or stucco surface, put the included plastic anchors into the holes. You may need to use a hammer to get the anchors in.

-If you're mounting the bracket on wood or vinyl surface,just use the included screws.

-Use the included screwdriver to tight all screws to the holes.

Step Three:


Screw your Soliom Camera to the mounted bracket.

Step Four:

Adjust the Soliom camera to a right angle so that you can catch the motions you want while avoiding the motions you don't.

(This can be adjusted again when you connect Soliom camera to your phone by a live view).

2. How to record videos and receive notifications in motion detection mode?

Step one:


Set up you phone in Permission Management to allow SOLIOM APP to send you notifications. Following this: Setting-Notifications-Soliom app- Click on Allow Notification.

Step Two:


Click the icon in the upper right in the APP to enter into device settings- click the accept call - choose Silence,Notification or call in as you preferred.

Step Three:


The PIR motion detection function is turned off by default, if you want to enable the motion detection, please click the video and get into the live streaming interface, find the Setting icon from the right bottom of the App. 

(Device Setting)Route: Device Setting - Pir detection-please choose a sensitivity or disabled it.

Step Four:

The video clips recorded by motion detection mode will be saved into the micro SD card or Cloud Storage, suggested to click on the Cloud storage from the App.

PS. If the PIR detection is turned off,the video clips can only be recorded into micro sd card)Route: Device Setting-SD card- Click on Cloud storage.